Forside » Dele & tilbehør» Motor & dele» Ventiltræk » Knastakselsæt 583G, tandhjulsdrevet
CAMSHAFT SET 583G GEAR-DRIVEN

Knastaksel · S&S Cycle

Knastakselsæt 583G, tandhjulsdrevet

Varenr. S&S CYCLE-330-0107

9.859,00 kr inkl. moms
Bestillingsvare fra USA · leveringstid 3-4 uger

Levering uden for Danmark: ekstra 3-7 dage i Europa

Bemærk

Varen bestilles hjem fra USA specielt til dig og kan ikke returneres. Fortrydelsesretten gælder ikke for denne vare.

Passer til 210 køretøjer · 59 modeller

MærkeKøretøjerModeller
Harley Davidson21059
Se alle 59 modeller

Fitment-tjekket: passer delen ikke som angivet, tager vi den retur. Vælg din motorcykel i garagen for at se, om den passer til din.

583G Gear Drive Camshaft Kit Not for '06 Dyna Cams for '00-'06 Twin Cams are for use with stock splined drive gears; for installation on '99 Twin Cams requires splined outer sprocket, S&S recommends Andrews 4340 steel drive… Læs mere

Beskrivelse fra leverandøren (engelsk)

583G Gear Drive Camshaft Kit

Not for '06 Dyna

Cams for '00-'06 Twin Cams are for use with stock splined drive gears; for installation on '99 Twin Cams requires splined outer sprocket, S&S recommends Andrews 4340 steel drive sprocket.

  • Reverses the rear cam's direction of rotation, providing additional operating clearance between cam lobes, making higher cam lifts possible
  • Increase valve timing accuracy by eliminating timing chain lash and loosely fit stock chain
  • Provides strong low end torque and horsepower
  • Strongest from 1500-5000 rpm
  • Material must be removed from inner surface of the stock gear cover to install
  • A hydraulic press and other professional level tools are required for installation
  • Cam bearings and gaskets must be replaced
  • S&S recommends that adjustable pushrod/cover kit be used (sold separately)
  • Kit includes camshafts, inner gears, outer drive gears, inner, outer bearings, gasket and instructions
  • Made in the USA
  • Due to inherent characteristics of gear drives, more valve train noise maybe heard.
  • Installer must check coil bind, valve to valve clearance and valve to piston clearance.
  • Not recommended for engines having compression ratios greater the 10.1:1.